Fault finder: ESP32-C3 greenhouse climate page

5 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

SHT31 not found: what should I check?

Check SDA on GPIO8, SCL on GPIO9 and the address 0x44 or 0x45.

Dots never stop: what should I check?

Check the Wi-Fi name and password, and that the network is 2.4 GHz.

Humidity stuck near 100 percent: what should I check?

Let the sensor dry out in a warm room, and shield it from spray.

Temperature reads high in the sun: what should I check?

Shade the sensor.

Page does not open: what should I check?

Use the exact address from the Serial Monitor and the same Wi-Fi.