Fault finder: ESP32-C3 hallway night glow
6 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.
0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6
ESP32 supply pin
Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.
You should see: 3.15 to 3.45 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Ring lights on its own: what should I check?
Wait the full 30 seconds, and keep the PIR away from heaters and sunlight.
Ring flickers or wrong colours: what should I check?
Keep the data wire short and add a 1000 microfarad capacitor across the ring supply.
Never lights: what should I check?
Check PIR OUT is on GPIO4 and the PIR has 5 V.
Board resets: what should I check?
The USB supply cannot give enough current, lower MAX_LEVEL or use a stronger adapter.
Stays lit all the time: what should I check?
Turn the PIR sensitivity dial down and aim it away from moving curtains.
