Fault finder: ESP32-C3 water bath thermometer

5 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Shows two dashes: what should I check?

The ratio is out of range, check the wiring of the divider.

Reads high or low: what should I check?

Check the fixed resistor value and the probe's beta number.

Dots never stop: what should I check?

Check the Wi-Fi name and password, and that the network is 2.4 GHz.

Graph is blank: what should I check?

Wait for two samples, one minute.

Noisy readings: what should I check?

Keep the probe leads away from the Wi-Fi antenna and from the USB lead.