Fault finder: ESP32-C3 height gained meter

11 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Sensor not found: what should I check?

Check the address 0x76 or 0x77 and the SDA and SCL wires.

Reading wobbles: what should I check?

Keep the board out of draughts and shade it from the sun.

Height drifts over hours: what should I check?

The weather changes the pressure, press the button again.

Wrong sign: what should I check?

The height should rise as you go up, check the formula line was not changed.

Display blank: what should I check?

Check the OLED address 0x3C.