Fault finder: ESP32-C3 room climate web page

5 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Serial Monitor shows nothing: what should I check?

Set USB CDC On Boot to Enabled in the Tools menu.

Sensor not found: what should I check?

Check SDA and SCL are on GPIO8 and GPIO9 and the module has 3.3 V.

Dots never stop: what should I check?

Check the Wi-Fi name and password, and that the network is 2.4 GHz.

Connects only near the router: what should I check?

Some SuperMini boards have a weak antenna; try WiFi.setTxPower(WIFI_POWER_8_5dBm) after WiFi.begin.

Page does not open: what should I check?

Make sure the phone is on the same Wi-Fi and use the exact address from the Serial Monitor.