Fault finder: ESP32 Bluetooth LED switch

7 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Device does not appear: what should I check?

Check the board is the original ESP32 and Bluetooth is enabled in the phone.

Cannot connect: what should I check?

Remove the old pairing and pair again.

No reply: what should I check?

Set the terminal app to send a newline at the end.

Compile error: what should I check?

Select ESP32 Dev Module and check Bluetooth classic is supported.

LED dark: what should I check?

Check polarity and GPIO26.