Fault finder: ESP32 keypad calculator

9 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Keys give the wrong character: what should I check?

Your keypad's pins may be in a different order, test with a short program that prints the row and column.

Some keys do nothing: what should I check?

Check the ribbon connector is pushed in fully and all eight wires are connected.

Two characters per press: what should I check?

Raise the debounce time from 30 to 50 milliseconds.

Display blank: what should I check?

Check the I2C wires and that the address is 0x3C.

Board will not boot with the keypad connected: what should I check?

Make sure the keypad is on the pins listed, not on GPIO12 or GPIO0.