Fault finder: ESP-NOW range and packet loss

9 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Compile error about rx_ctrl: what should I check?

You are on core 2: use the older callback and drop the RSSI line.

No messages arrive: what should I check?

Both sketches need WiFi.mode(WIFI_STA) before ESP-NOW starts.

Blank screen: what should I check?

Check GPIO 21 and 22 and try address 0x3D.

Lost count jumps at the start: what should I check?

Restart the receiver after the sender is running.

Results vary a lot: what should I check?

Wait for twenty messages at each step and repeat.