Fault finder: Green roof moisture sensors

7 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Always 0 or 100: what should I check?

Calibration values are off. Re-measure dry and wet readings.

Page will not load: what should I check?

Check the IP address and that your phone is on the same Wi-Fi.

SHT31 reads nan: what should I check?

Check I2C wiring and the 0x44 address.

Readings jump: what should I check?

Keep wires short and put the blade fully in the soil.