Fault finder: Hand-programmed EEPROM lookup table

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Display stays blank: what should I check?

Check the common pins and the resistors.

Wrong characters: what should I check?

Check which Nano pin goes to which segment (D2 is a, D8 is g).

Reads return 255: what should I check?

The EEPROM is not found. Check the address pins and I2C wires.

Writes do not stick: what should I check?

Make sure WP is on ground and wait for the write cycle.