Fault finder: Table-top robot that never falls off

7 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Robot drives off the edge: what should I check?

EDGE is the wrong level, the sensors are too high or the turn starts too late. Lower the speed.

Robot spins on the spot on the table: what should I check?

The sensor trimmers are set too sensitive for the table colour. Turn them back.

Wheels turn the wrong way: what should I check?

Swap the IN pins for that motor.

Sensor fooled by black tables: what should I check?

Black surfaces reflect little IR. Test the material first or use a different table.