Fault finder: ECG heart signal plotter

5 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Noisy, wandering trace: what should I check?

Dry the skin, press the pads, sit still, keep cables from swinging.

No R peaks: what should I check?

Check pad positions and the RL pad.

Bpm jumps: what should I check?

Threshold too low; sit still for a few seconds while it adapts.

Plot flat at 0: what should I check?

A lead is off or a pad is dry.

Heavy hum: what should I check?

Keep away from mains cables and chargers.