Fault finder: Earthquake shake logger

8 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Events every second: what should I check?

The threshold is too low or the sensor is loose. Fix it down and raise 0.05.

Never triggers: what should I check?

Lower the threshold, and check the sensor data rate setting.

Writing fails: what should I check?

Check the SD card is FAT32 and the CS pin.

Time stamps wrong: what should I check?

Set the DS3231 and check its coin cell.