Fault finder: Bare sensor probe build

7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No sensor found: what should I check?

Check the pull-up and the D2 wire.

Reads 85 C: what should I check?

The sensor has not finished its first conversion, wait a second.

Reads -127 C: what should I check?

Data line broken, check wiring.

Sensor very hot: what should I check?

Wrong way round, unplug at once.

LCD blank: what should I check?

Try address 0x3F and adjust the contrast pot on the backpack.