Fault finder: Drawer opening logger

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No lines written: what should I check?

Check SD format and CS pin D10.

OPEN logged all the time: what should I check?

Drawer not dark enough; lower the levels or shade the sensor.

Wrong times: what should I check?

RTC not set, or the coin cell is flat.

Batteries drain in days: what should I check?

Expected; cut the Nano power LED and use a bigger battery pack.

Two OPEN rows in a row: what should I check?

Levels too close; widen the gap.