Fault finder: Double-clap light switch

7 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Never reacts: what should I check?

Turn the trimmer until the DO LED just goes off in silence, then test again.

Toggles on any noise: what should I check?

The module is too sensitive. Turn the trimmer back a little.

Toggles twice: what should I check?

Raise the delay(120) to 200 so one clap's echo is not counted.