Projects / Door open notifier / Fault finder

Fault finder: Door open notifier

10 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

LED on when the door is shut: what should I check?

Your switch is normally closed: swap HIGH for LOW in the open test.

Random triggers: what should I check?

Long wires pick up noise: add 100 nF from GPIO27 to GND.

Buzzer quiet: what should I check?

Power it from 5V through the transistor, not from the 3.3 V pin.