Fault finder: Three diodes compared

5 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Vd near 4.5 V: what should I check?

The diode is reversed, swap it.

Current reads negative: what should I check?

Check A0 and A1 are on the right nodes.

Readings vary: what should I check?

Keep wires short and measure the real VCC.

No output: what should I check?

Check the serial monitor ends lines with newline.

Pin warm: what should I check?

Use at least 330 ohm and switch the drive off between tests.