Fault finder: Digital slide rule
13 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 13 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 13
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Blank screen: what should I check?
Check the OLED wires and try address 0x3D.
Numbers jitter: what should I check?
Knobs are noisy, so average a few readings if you like.
Hairline in the wrong place: what should I check?
Check LEN and X0 are the same in every place.
Button does nothing: what should I check?
Check it goes to D2 and GND.
Upload fails: what should I check?
Choose the Old Bootloader option for the Nano.
