Fault finder: Desk climate monitor

12 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 12 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 12

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

BME280 not found at 0x76: what should I check?

Try 0x77 in bme.begin(). Check SDA and SCL are not swapped. Run an I2C scanner sketch to see which addresses answer.

Humidity reads 0 or nan: what should I check?

Your board is probably a BMP280, which has no humidity sensor.

OLED stays blank: what should I check?

Try address 0x3D. Check it is a 128 × 64 module, and that VCC and GND are not swapped.

Temperature reads several degrees high: what should I check?

Move the sensor away from the ESP32 and regulator, which warm it.

Upload fails: what should I check?

Use a data-capable USB cable, select the right port, and hold BOOT while uploading if needed.