Fault finder: Desk busy light
9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
A light stays dark: what should I check?
Check its direction and its 220 ohm resistor.
Both lights are dim: what should I check?
Check the long press did not set dim mode.
Button does nothing: what should I check?
Check it goes to D2 and GND.
Status skips: what should I check?
Check the button is across the breadboard gap and not bouncing.
Meeting never ends: what should I check?
Check MEETING_MS in the code.
