Fault finder: Decoupling capacitor noise lab

5 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 5 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 5

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No difference with noise on: what should I check?

Run the noise wire right alongside the A0 wire and twist them loosely.

Spread is large even with no noise: what should I check?

Check the resistors are firm in the breadboard.

Mean is not near 512: what should I check?

Check both resistors are 10 kilohms.

Nothing prints: what should I check?

Set 115200 baud in the monitor.

Capacitor seems to have no effect: what should I check?

Check both legs are in the right rows.