Fault finder: Address decoder lab with a 74HC138

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

No LED lights: what should I check?

Check the three enable pins and the power pins.

Two LEDs light: what should I check?

One input is floating, add or check its pull-up.

Wrong LED for a code: what should I check?

Remember on means 0 and pins are A=1, B=2, C=3.

LED very dim: what should I check?

Check the 1 kilohm values and the LED direction.

Chip gets warm: what should I check?

Check for a short on the outputs and the power rails.