Fault finder: Ten-step counter display

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing moves: what should I check?

Pin 13 must go to GND.

LEDs light in the wrong order: what should I check?

Check the output pin order 3, 2, 4, 7, 10, 1, 5, 6, 9, 11.

Skipped steps: what should I check?

The clock line is noisy, add a 100 nF capacitor from pin 14 to GND.

Two LEDs lit: what should I check?

Reset is floating, wire it to D3.

LEDs very dim: what should I check?

Use a low-current LED.