Fault finder: Darkness sensor with two transistors

11 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

LED never lights: what should I check?

Transistor pins are wrong. For a BC547 facing flat side you, the order is collector, base, emitter from left to right.

LED always on: what should I check?

The pot is set too high, or the LDR is shorted. Turn the pot down.

LED dim: what should I check?

Normal for a Darlington at 9 V. Use 220 Ω for brighter.

Switches back and forth in half-light: what should I check?

There is no hysteresis. That is a good lesson for the comparator lab.