Fault finder: Diode and LED curve tracer
7 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
No current: what should I check?
Reverse the part.
Curve is noisy: what should I check?
Average more readings.
Output stops rising: what should I check?
The op-amp limits near 3.5 V; stay below that.
