Fault finder: USB current and energy meter

10 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Shows 0 mA: what should I check?

The load is on the wrong side, or VIN+ and VIN- are swapped. Current flows from VIN+ to VIN-.

Voltage low under load: what should I check?

The shunt and thin wires drop voltage. Use short, thick wires.

Phone does not fast-charge: what should I check?

Data lines are not joined or the charger needs a negotiation chip.

Display blank: what should I check?

Check the I2C addresses 0x40 and 0x3C and wiring.