Fault finder: Cup anemometer for wind speed
9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Zero reading: what should I check?
Check the slot sensor LED blinks as slots pass.
Reading jumps: what should I check?
Check the disc does not wobble in the sensor gap.
Too slow to start: what should I check?
Reduce friction and use light cups.
Reading too high or low: what should I check?
Recalibrate K against a known speed.
