Fault finder: CRC error detection lab

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing prints: what should I check?

Check the data wire, shared ground and both uploads.

Always FAIL: what should I check?

Check both sketches use the same CRC code.

Garbled letters: what should I check?

SoftwareSerial is best at 9600, check the wires are short.

Button has no effect: what should I check?

Check the buttons go to D4 and D5 and GND.

Upload fails: what should I check?

Choose the Old Bootloader option.