Fault finder: Continuity tester with a buzzer

10 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Always shows Open: what should I check?

Check the probe lead reaches A0 and the other lead goes to GND.

Beeps with probes apart: what should I check?

A0 is shorted to ground, check the wiring.

Readings are off: what should I check?

Put the real pull-up value in R_PULLUP.

Buzzer never sounds: what should I check?

Use an active buzzer and check its polarity.

Damage risk: what should I check?

Only use on unpowered circuits with capacitors discharged.