Fault finder: Op-amp constant current sink

9 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Current too high or unstable: what should I check?

Add the gate resistor and keep leads short; check pin 2 goes to the source side of the 10 Ω.

LED does not light: what should I check?

Check the LED direction and the drain wiring.

Current is zero: what should I check?

Check the reference reaches pin 3.

MOSFET warms: what should I check?

Lower the current; it should be barely warm at this setting.