Fault finder: Component bag QR labeller
7 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Label too small to scan: what should I check?
Increase the QR size or print larger.
KeyError: what should I check?
Check the column names in the CSV.
ModuleNotFoundError: what should I check?
Install the libraries with apt.
