Fault finder: Window comparator voltage monitor
9 checks for this build on the board. Work from the top: power first, then each part, then the code.
0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9
board supply pin
Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Both LEDs on: what should I check?
Output W sits at a middle voltage. Check the pull-up and the BC547 base resistor.
Neither LED on: what should I check?
No power on the LM393 or the pin numbers are shifted.
Switches at the wrong voltage: what should I check?
The resistors are not equal. Measure and use the measured thresholds.
LEDs flicker near a threshold: what should I check?
Comparators without hysteresis chatter. This is normal in this lab.
