Fault finder: Status light with a common-anode RGB LED

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Colours are inverted: what should I check?

You have a common-cathode part, wire the common leg to GND and remove the inversion.

Only one colour works: what should I check?

Check each resistor reaches its pin.

Too dim: what should I check?

Check the 220 ohm values and that the common leg is on 5V.

White looks pink: what should I check?

Red is stronger, lower the red value a little.

Button double-steps: what should I check?

Increase the 40 millisecond debounce.