Fault finder: Colour reader and matcher

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Colours look washed out: what should I check?

The sensor is too far from the object. Hold it a few millimetres away.

Always shows the same colour: what should I check?

The white balance was set on a coloured surface. Redo it on white paper.

Sensor is not found: what should I check?

Check SDA and SCL are not swapped and the board is powered.

Values change with room light: what should I check?

Add a shroud around the sensor and the object.