Fault finder: CO2 and light monitor for a grow tent

7 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

CO2 reads zero: what should I check?

Wait the first 30 seconds after power on.

SD fails: what should I check?

Format FAT32 and check the 5V supply to the module.

DLI too high: what should I check?

Use a quantum meter to correct the factor.

I2C errors: what should I check?

Check the shared wiring and addresses.