Fault finder: Classroom CO2 traffic light

11 checks for this build on the ESP32. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

ESP32 supply pin

Plug the ESP32 into USB. Black probe on a GND pin, red probe on the 3V3 pin of the board.

You should see: 3.15 to 3.45 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

SCD40 not found: what should I check?

Check SDA/SCL and 3V3, and that no other device uses address 0x62.

Reads much too high outdoors: what should I check?

Leave it running for a week near a window at times, or run forced recalibration from the library example.

Temperature reads warm: what should I check?

The ESP32 heats nearby air. Keep the sensor a few cm away from the board.