Fault finder: Desk tree LED sequencer

11 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

A LED never lights: what should I check?

Check its direction and its pin number in the table.

Patterns too fast to see: what should I check?

Turn the knob fully one way, or raise the 600 limit.

LEDs look dim in breathing: what should I check?

Only pins 3, 5, 6, 9 and 10 can fade.

Button skips patterns: what should I check?

Increase the 30 ms debounce.

Uno gets warm: what should I check?

Too many LEDs on at once, use fewer lit LEDs per frame.