Fault finder: Schmitt NAND oscillator

10 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing happens: what should I check?

Check pins 14 and 7 and the battery clip.

Output stays high or low: what should I check?

Check pins 1 and 2 are tied and the capacitor is in place.

Blink too fast to see: what should I check?

Use the 10 microfarad part, not 100 nanofarad.

No sound: what should I check?

Use a passive buzzer and the 100 nanofarad capacitor.

Frequency drifts: what should I check?

Supply voltage changes the frequency, use a fresh battery.