Fault finder: Ten-step LED sequencer

12 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 12 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 12

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Nothing lights: what should I check?

Check pins 16, 8 and 13 and that pin 15 is held low.

Lights jump around: what should I check?

A floating reset pin, check the 10 kilohm pull-down.

Counter does not step: what should I check?

Check the clock reaches pin 14 and pin 13 is grounded.

Order is wrong: what should I check?

The outputs are not in pin order, use the pin map in the notes.

LEDs too dim: what should I check?

Use high-brightness LEDs, not larger currents on the outputs.