Fault finder: Car battery voltage monitor

11 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Reading far too high: what should I check?

Check the divider values and VREF.

Display shows 0: what should I check?

Check A0 and the lower resistor.

Resets when starting the engine: what should I check?

Add a 1000 µF capacitor on the buck input.

Noisy reading: what should I check?

Average more samples.