Fault finder: Capacitor charge and discharge lab

8 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Tau far from expected: what should I check?

Check R_OHMS in the sketch and the part values.

Curve is noisy: what should I check?

Add short wires and keep the breadboard away from motors.

Final voltage below 5 V: what should I check?

Measure the board 5V pin with a meter, USB supplies can sit near 4.7 V.

Nothing happens on press: what should I check?

Check the button goes to D2 and GND.

Capacitor feels warm: what should I check?

Stop and check polarity.