Fault finder: Capacitor charge curve

6 checks for this build on the Uno. Work from the top: power first, then each part, then the code.

0 of 6 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 6

Uno supply pin

Plug the Uno into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Straight line at 5 V: what should I check?

Capacitor not connected or reversed.

Never reaches 3.16 V: what should I check?

Leaky or reversed capacitor, or a 100 kΩ resistor by mistake.

Curve starts high: what should I check?

Discharge time too short; increase the first delay.