Fault finder: Network and ribbon cable tester

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Everything reports open: what should I check?

Check the far-end ground reference, the jack pin order and the 165 load pin.

LEDs stay lit: what should I check?

Check the 165 inputs are not floating and the LED resistors go to ground.

Reports wrong pin numbers: what should I check?

Check Q0 to Q7 order and the MSB/LSB direction of the wiring.

Nothing happens: what should I check?

Check 595 pin 10 is high and pin 13 is low.