Fault finder: Digital bubble level
8 checks for this build on the Nano. Work from the top: power first, then each part, then the code.
0 of 8 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 8
Nano supply pin
Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.
You should see: 4.6 to 5.3 V
Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.
Common faults in this build
Dot jumps: what should I check?
Increase the averaging.
Angles squashed: what should I check?
Check AREF is wired to 3.3 V.
Wrong direction: what should I check?
Swap the signs for roll or pitch.
Matrix blank: what should I check?
Check DIN, CLK and CS order and the 5 V supply.
