Fault finder: Small MOSFET switch with a BS170

9 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 9 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 9

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

LEDs never light: what should I check?

Check the pinout, it may be reversed.

LEDs always on: what should I check?

Check the pull-down and that the gate is not floating.

LEDs dim even at full: what should I check?

The BS170 is not fully on at 5 V, accept this or use a logic-level part.

Flicker at low duty: what should I check?

Normal PWM behaviour at 490 Hz.

Transistor warm: what should I check?

Check the resistors are 330 ohm.