Fault finder: Breadboard rail gotchas lab

7 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 7 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 7

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Meter never beeps: what should I check?

Check the probes are pushed in, and touch them together first.

Beeps everywhere: what should I check?

The meter is in the wrong mode or a probe is touching metal at both points.

LED never lights: what should I check?

Check its direction and that the resistor is in the circuit.

LED very bright: what should I check?

Use the 470 ohm resistor, not a smaller one.

Rails differ from this board: what should I check?

Your board may be split or continuous, so write down what you find.