Fault finder: Contactless thermometer kiosk

10 checks for this build on the Nano. Work from the top: power first, then each part, then the code.

0 of 10 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 10

Nano supply pin

Plug the Nano into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Always reads about room temperature: what should I check?

The sensor is pointing at the wrong place or too far away.

Readings vary: what should I check?

Keep the distance the same and wait for a steady position.

Nothing triggers: what should I check?

Print the VL53L0X distance and adjust NEAR_MM and FAR_MM.

Device not found: what should I check?

Check I2C wiring and each module's supply voltage.