Fault finder: 12-bit voltmeter on a Blue Pill

11 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 11 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 11

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

Value stuck at maximum: what should I check?

Check the wiper goes to PA0.

Reading jumps around: what should I check?

Keep wires short and add a 100 nanofarad capacitor from PA0 to GND.

Volts do not match the meter: what should I check?

Measure the 3.3 V pin and update VREF.

Blank screen: what should I check?

Check the OLED address and I2C wires.

Upload fails: what should I check?

Check the ST-Link wires and boot jumpers.