Fault finder: Black Pill two-channel voltmeter

13 checks for this build on the board. Work from the top: power first, then each part, then the code.

0 of 13 checked
Power🔧 DC volts, 20 V rangeCheck 1 of 13

board supply pin

Plug the board into USB. Black probe on a GND pin, red probe on the 5V pin of the board.

You should see: 4.6 to 5.3 V

V

Readings are compared with the ranges for this build's parts. A meter on the wrong range or a loose probe gives odd numbers: check those first.

Common faults in this build

A and B change together: what should I check?

Check each wiper goes to its own pin.

Readings jump: what should I check?

Keep wires short and add 100 nanofarad from each input to GND.

Values do not match the meter: what should I check?

Measure the 3.3 V pin and update VREF.

Blank screen: what should I check?

Check the OLED address and I2C wires.

Upload fails: what should I check?

Check the ST-Link wires and the board settings.